136 | VLAN Commands
www.dell.com | support.dell.com
Usage
Information
For the show vlan id vlan-id command, the output is shown in the following example:
Example
Figure 7-44. Output of the show vlan id Command
Description of the fields in the show vlan id report:
VLAN Id: VLAN number
Status: A VLAN is active only if the VLAN contains interfaces and those interfaces are operationally
up.
Q: (T) tagged or (U) untagged information
Ports: Speed - whether it is 10G, 1G or fast Ethernet interface and port number (unit/slot/port).
The “^” indicates the native VLAN.
“Po” indicates a port channel (also called a LAG)
show vlan association mac
This command displays the information about either all IP subnet-based VLANs or the VLAN
associated with a specific IP address and mask.
Syntax
show vlan association mac [mac]
Parameters
Mode
Privileged Exec
Command
History
Usage
Information
Examples of using the show vlan association mac command, with and without the mac variable,
are shown in Figure 7-45.
Force10#R1 #show vlan id 2
Codes: * - Default VLAN, G - GVRP VLANs, E - Ethernet interface, ^ - Native Vlan
VlanId Status Q Ports
------ --------- - --------
2 Active U E ^1/0/20,^1/0/21,^1/0/22,^1/0/24
T E 1/0/40, 1/0/42, 1/0/43, 1/0/44
U ^Po1 ( 1/0/35, 1/0/36, 1/0/37)
U ^Po2 ( 1/0/10)
U ^Po3 ( 1/0/15)
Note: The S50V and S25P support MAC-based VLANs. The original S50 does not.
mac (OPTIONAL) For mac, enter the MAC address to be used for retrieving
information about the associated VLAN.
Version 2.5.1 Introduced
To Next Page
Loading...
