Dell Force10 S2410-01-10GE-24P - Area Virtual-Link Retransmit-Interval; Area Virtual-Link Transmit-Delay

OSPF Commands | 429
The no area areaid virtual-link neighbor hello-interval command invokes the default hello
interval for the OSPF virtual interface on the virtual interface identified by
areaid and
neighbor.
Default
10
Mode
Router OSPF Config
Related
Commands
area virtual-link retransmit-interval
This command configures the retransmit interval for the OSPF virtual interface on the virtual interface
identified by areaid and neighbor. The neighbor parameter is the Router ID of the neighbor. The
range for seconds is 0 to 3600.
The no version of this command configures the default retransmit interval for the OSPF virtual
interface on the virtual interface identified by areaid and neighbor. The neighbor parameter is the
Router ID of the neighbor.
Syntax
area areaid virtual-link neighbor retransmit-interval 0-3600
no area areaid virtual-link neighbor retransmit-interval
Default
5
Mode
Router OSPF Config
area virtual-link transmit-delay
This command configures the transmit delay for the OSPF virtual interface on the virtual interface
identified by areaid and neighbor. The neighbor parameter is the Router ID of the neighbor. The
range for seconds is 0 to 3600 (1 hour).
The no version of this command configures the default transmit delay for the OSPF virtual interface
on the virtual interface identified by areaid and neighbor. The neighbor parameter is the Router ID of
the neighbor.
Syntax
area areaid virtual-link neighbor transmit-delay 0-3600
no area areaid virtual-link neighbor transmit-delay
Default
1
Mode
Router OSPF Config
show ip ospf
interface
Displays the information for the IFO object or virtual interface tables