Dell Force10 S2410-01-10GE-24P - Ip Igmp Version; Ip Igmp Startup-Query-Interval

IP Multicast Commands | 475
The range for count is 1 to 20.
The no ip igmp startup-query-count command resets the number of Queries sent out on startup,
separated by the Startup Query Interval on the interface to the default value.
Default
2
Mode
Interface Config; Interface VLAN
Command
History
ip igmp startup-query-interval
This command sets the interval between general queries sent by a querier on startup on the interface or
VLAN.
Syntax
ip igmp startup-query-interval interval
The range for interval is 1 to 300 seconds.
The no ip igmp startup-query-interval command resets the interval between general queries sent
by a querier on startup on the interface to the default value.
Default
31
Mode
Interface Config; Interface VLAN
Command
History
ip igmp version
This command configures the version of IGMP for an interface or VLAN.
Syntax
[no] ip igmp version version
The value for version is either 1, 2 or 3 (for IGMP version 1, 2, or 3, respectively)
The no version of this command resets the version of IGMP for this interface.The version is
reset to the default value.
Default
3
Mode
Interface Config; Interface VLAN
Command
History
Version 2.3 Modified: Added Interface VLAN mode.
Version 2.3 Modified: Added Interface VLAN mode.
Version 2.3 Modified: Added Interface VLAN mode.