Dell Force10 S2410-01-10GE-24P - Clear Ip Dhcp Binding; Clear Ip Dhcp Conflict

232 | DHCP Server Commands
www.dell.com | support.dell.com
bootfile
The command specifies the name of the default boot image for a DHCP client. The filename specifies
the boot image file.
The oe version of this command deletes the boot image name.
Syntax
bootfile filename
no bootfile
Default
none
Mode
DHCP Pool Config
clear ip dhcp binding
This command deletes an automatic address binding from the DHCP server database. If “*” is
specified, the bindings corresponding to all the addresses are deleted. address is a valid IP address
made up of four decimal bytes ranging from 0 to 255. IP address 0.0.0.0 is invalid.
Syntax
clear ip dhcp binding {address | *}
Default
none
Mode
Privileged Exec
clear ip dhcp server statistics
This command clears DHCP server statistics counters.
Syntax
clear ip dhcp server statistics
Mode
Privileged Exec
clear ip dhcp conflict
The command is used to clear an address conflict from the DHCP Server database. The server detects
conflicts using a ping. DHCP server clears all conflicts If the asterisk (*) character is used as the
address parameter.
Syntax
clear ip dhcp conflict {address | }
Default
none
Mode
Privileged Exec