System Management Commands | 35
5
System Management Commands
The commands in this chapter either manage the switch in general, configure management interfaces,
or show current management settings. For every configuration command, there is a nieA command
that displays the configuration setting.
This chapter contains the following major sections:
• General System Management and Information Commands on page 35
• Telnet Commands on page 71
• remotecon maxsessions on page 73
• SNMP Management Commands on page 77
General System Management and Information Commands
This section describes the following commands:
• cx4-cable-length on page 36
• dir on page 37
• hostname on page 37
• interface managementethernet on page 38
• ip address (management) on page 38
• mac-address on page 39
• mac-type on page 39
• management route default on page 40
• network mac-address on page 41
• network mac-type on page 41
• network parms on page 41
• network protocol on page 41
• protocol on page 41
• show arp switch on page 42
• show cx4-cable-length on page 43
• show ethernet
• show hardware on page 46
• show interface on page 47
• show interface ethernet on page 50
• show interface managementethernet on page 57
• show interface switchport on page 59
Note: See also Chapter 6, “System Configuration Commands,” on page 87 and
Chapter 9, “System Logs,” on page 169.
To Next Page
Loading...
