Dell Force10 S2410-01-10GE-24P - Show Ip Mcast Boundary; Show Ip Mcast Mroute; Show Ip Mcast Interface

462 | IP Multicast Commands
www.dell.com | support.dell.com
show ip mcast boundary
This command displays all the configured administrative scoped multicast boundaries.
Syntax
show ip mcast boundary {unit/slot/port | all}
Mode
Privileged Exec and User Exec
Report Fields Unit/Slot/Port—Valid unit, slot and port number separated by forward slashes.
Group Ip—The group IP address
Mask—The group IP mask
show ip mcast interface
This command displays the multicast information for the specified interface.
Syntax
show ip mcast interface unit/slot/port
Mode
Privileged Exec and User Exec
Report Fields Unit/Slot/Port—Valid unit, slot and port number separated by forward slashes.
TTL—This field displays the time-to-live value for this interface.
show ip mcast mroute
This command displays a summary or all the details of the multicast table.
Syntax
show ip mcast mroute {detail | summary}
Mode
Privileged Exec and User Exec
Report Fields
If the “detail” parameter is specified, the following fields are displayed:
Source IP Addr—This field displays the IP address of the multicast data source.
Group IP Addr—This field displays the IP address of the destination of the multicast packet.
Expiry Time—This field displays the time of expiry of this entry in seconds.
Up Time—This field displays the time elapsed since the entry was created in seconds.
RPF Neighbor—This field displays the IP address of the RPF neighbor.
Flags—This field displays the flags associated with this entry.
If the “summary” parameter is specified, the following fields are displayed:
Source IP Addr—This field displays the IP address of the multicast data source.