Dell Force10 S2410-01-10GE-24P Command Reference

IP Multicast Commands | 461
The default value of group is 224.2.0.1.
Mode
Privileged Exec
no ip mcast mroute
This command is used to clear entries in the mroute table. The all parameters is used to clear all entries.
Syntax
no ip mcast mroute {group groupipaddr | source sourceipaddr [groupipaddr] | all}
The source parameter is used to clear the routes in the mroute table entries containing the specified
sourceipaddr or sourceipaddr [groupipaddr] pair. The source address is the source IP address of
the multicast packet. The group address is the Group Destination IP address of the multicast packet.
The group parameter is used to clear the routes in the mroute table entries containing the specified
groupipaddr. The group address is the Group Destination IP address of the multicast packet.
Default
none
Mode
Global Config
show ip mcast
This command displays the system-wide multicast information.
Syntax
show ip mcast
Mode
Privileged Exec and User Exec
Report Fields Admin Mode—This field displays the administrative status of multicast. This is a configured value.
Protocol State—This field indicates the current state of the multicast protocol. Possible values are
Operational or Non-Operational.
Table Max Size—This field displays the maximum number of entries allowed in the multicast table.
Number Of Packets For Which Source Not Found—This displays the number of packets for which the
source is not found.
Number Of Packets For Which Group Not Found—This displays the number of packets for which the
group is not found.
Protocol—This field displays the multicast protocol running on the router. Possible values are PIMDM,
PIMSM, or DVMRP.
Entry Count—This field displays the number of entries in the multicast table.
Highest Entry Count—This field displays the highest entry count in the multicast table.

Dell Force10 S2410-01-10GE-24P Specifications

General

Manageable	Yes
Jumbo Frame Support	Yes
Product Type	Switch
Uplink Ports	4 x 10 Gigabit SFP+
MAC Address Table Size	32K entries
Operating Temperature	0 °C to 40 °C
Storage Temperature	-40 °C to 70 °C
Power Supply	Internal