System Logs | 175
Related
Commands
show logging eventlog
This command displays the event log (persistent log, error log).
Syntax
show logging eventlog [unit]
Parameters
Default
If the unit is not specified, the displayed event log is that of the management unit.
Mode
Privileged Exec
Command
History
Example
Figure 9-62. Sample Output from the show logging Command
Report Fields
File—The file in which the event originated
Line—The line number of the event
Task ID—The task ID of the event
Code—The event code
Time—The time this event occurred. “d h m s” indicates the number of days (d), hours (h), minutes (m),
and seconds (s) after the switch was booted that the event occurred.
logging buffered Enables logging of the system log to RAM and any other enabled destination,
including the console and any enabled syslog server.
logging cli-command Displays CLI activity in the log.
logging facility Configure the Syslog facility, used for error messages sent to Syslog servers.
show logging eventlog Displays the persistent event log.
show logging traplogs Displays the SNMP trap log.
unit
(OPTIONAL) Specify a particular stack member.
Version 2.5.1
Modified: This command is revised from
show eventlog.
Force10 ##show logging eventlog
File Line TaskID Code d h m s
EVENT> bootos.c 434 0FFFFE00 AAAAAAAA 0 0 0 10
ERROR> unitmgr.c 3325 0E14B970 00000000 0 0 11 16
EVENT> bootos.c 434 0FFFFE00 AAAAAAAA 0 0 0 9
ERROR> unitmgr.c 3325 0E14B970 00000000 4 2 53 36
EVENT> bootos.c 434 0FFFFE00 AAAAAAAA 0 0 0 9
ERROR> unitmgr.c 3325 0E41C9B8 00000000 0 0 7 16