Dell Force10 S2410-01-10GE-24P - Show Ip Ospf Virtual-Link Brief

448 | OSPF Commands
www.dell.com | support.dell.com
show ip ospf virtual-link brief
This command displays the OSPF Virtual Interface information for all areas in the system.
Syntax
show ip ospf virtual-link brief
Mode
Privileged Exec and User Exec
Report Fields
Area Id—Is the area ID of the requested OSPF area.
Neighbor—Is the neighbor interface of the OSPF virtual interface.
Hello Interval—Is the configured hello interval for the OSPF virtual interface.
Dead Interval—Is the configured dead interval for the OSPF virtual interface.
Retransmit Interval—Is the configured retransmit interval for the OSPF virtual interface.
Transit Delay—Is the configured transit delay for the OSPF virtual interface.
trapflags
This command enables and disables OSPF traps.
Syntax
[no] trapflags
The no trapflags command disables OSPF traps.
Default
enabled
Mode
Router OSPF Config
Usage
Information
Use this command in conjunction with other SNMP management commands, described in SNMP
Management Commands on page 77.