Dell Force10 S2410-01-10GE-24P - Set Igmp Groupmembership-Interval All; Set Igmp Interfacemode All

280 | IGMP Snooping Commands
www.dell.com | support.dell.com
set igmp groupmembership-interval all
This command sets the IGMP Group Membership Interval time on the system for all the interfaces.
The Group Membership Interval time is the amount of time in seconds that a switch will wait for a
report from a particular group on a particular interface before deleting the interface from the entry.
Syntax
set igmp groupmembership-interval all 2-3600
This variable must be greater than the IGMP Maximum Response time value. The range is 2 to 3600
seconds.
The no set igmp groupmembership-interval all command sets the IGMP Group Membership
Interval time on all interfaces to the default value.
Default
260 seconds
Mode
Global Config
Related
Commands
set igmp interfacemode all
Command
History
Related
Commands
set igmp maxresponse
This command sets the IGMP Maximum Response time on the system. The Maximum Response time
is the amount of time in seconds that a switch will wait after sending a query on an interface because it
did not receive a report for a particular group in that interface. This value must be less than the IGMP
Query Interval time value. The range is 1 to 3599 seconds.
The no version of this command sets the IGMP Maximum Response time on the system to 10 seconds.
Syntax
set igmp maxresponse 1-3599
no set igmp maxresponse
Default
10
Mode
Global Config
igmp enable (interface) Enables IGMP Snooping on a selected interface.
show igmpsnooping Displays IGMP Snooping status information.
Version 2.3 Changed to igmp interfacemode enable all
igmp interfacemode enable all Sets the IGMP Group Membership Interval time on a
particular interface.
igmp enable (interface) Enables IGMP Snooping on a selected interface.