Dell Force10 S2410-01-10GE-24P Command Reference

80 | System Management Commands
www.dell.com | support.dell.com
snmp-server community
This command adds (and names) a new SNMP community. A community name is a name associated
with the switch and with a set of SNMP managers that manage it with a specified privileged level. The
length of name can be up to 16 case-sensitive characters.
Syntax
snmp-server community name
The no snmp-server community name command removes the specified community name from
the SNMP community table.
Default
None
Mode
Global Config
snmp-server community ipaddr
This command sets a client IP address for an SNMP community. The address is the associated
community SNMP packet-sending address and is used along with the client IP mask value to denote a
range of IP addresses from which SNMP clients may use that community to access the device. A value
of 0.0.0.0 allows access from any IP address. Otherwise, this value is ANDed with the mask to
determine the range of allowed client IP addresses. The name is the applicable community name.
Syntax
snmp-server community ipaddr ipaddr name
Use no snmp-server community ipaddr name to reset a client IP address for an SNMP
community to 0.0.0.0. The name is the applicable community name.
Default
0.0.0.0
Mode
Global Config
snmp-server community ipmask
This command sets a client IP mask for an SNMP community. The address is the associated
community SNMP packet sending address and is used along with the client IP address value to denote
a range of IP addresses from which SNMP clients may use that community to access the device. A
value of 255.255.255.255 will allow access from only one station, and will use that machine's IP
address for the client IP Address. A value of 0.0.0.0 will allow access from any IP address. The name is
the applicable community name.
Syntax
snmp-server community ipmask ipmask name
Use no snmp-server community ipmask name to reset a client IP mask for an SNMP
community to 0.0.0.0. The name is the applicable community name. The community name may be up
to 16 alphanumeric characters.
Note: Community names in the SNMP community table must be unique. When making
multiple entries using the same community name, the first entry is kept and processed and all
duplicate entries are ignored.

Dell Force10 S2410-01-10GE-24P Specifications

General

Manageable	Yes
Jumbo Frame Support	Yes
Product Type	Switch
Uplink Ports	4 x 10 Gigabit SFP+
MAC Address Table Size	32K entries
Operating Temperature	0 °C to 40 °C
Storage Temperature	-40 °C to 70 °C
Power Supply	Internal