Dell Force10 S2410-01-10GE-24P Command Reference

VLAN Commands | 145
Related
Commands
vlan port tagging all
This command sets the tagging behavior for all interfaces in a VLAN to enabled.
Mode
Global Config
Command
History
Related
Commands
vlan port untagging all
This command sets the tagging behavior for all interfaces in a VLAN to disabled so that traffic is
transmitted as untagged frames.
Mode
Global Config
Command
History
Related
Commands
vlan protocol group
This command adds a protocol-based VLAN group to the system. The groupname is a character string
of 1 to 16 characters. When it is created, the protocol group is assigned a unique number that will be
used to identify the group in subsequent commands.
Syntax
vlan protocol group groupname
Mode
Global Config
Command
History
Related
Commands
tagged Configure a tagged interface in the selected VLAN.
untagged Configure an untagged interface in the selected VLAN.
Version 2.5.1 Deprecated. Removed from CLI
tagged Configure a tagged interface in the selected VLAN.
untagged Configure an untagged interface in the selected VLAN.
Version 2.5.1 Deprecated. Removed from CLI
tagged Configure a tagged interface in the selected VLAN.
untagged Configure an untagged interface in the selected VLAN.
Version 2.5.2 Unsupported: not tested in 2.5.2
Version 2.5.1 Unsupported: not tested in 2.5.1
vlan protocol group
add protocol
Add the named protocol to the protocol-based VLAN identified by
groupid.
vlan protocol group
remove
Remove the protocol-based VLAN group that is identified by the
groupid.
protocol group Attach a group ID to the selected VLAN.

Dell Force10 S2410-01-10GE-24P Specifications

General

Manageable	Yes
Jumbo Frame Support	Yes
Product Type	Switch
Uplink Ports	4 x 10 Gigabit SFP+
MAC Address Table Size	32K entries
Operating Temperature	0 °C to 40 °C
Storage Temperature	-40 °C to 70 °C
Power Supply	Internal