Dell Force10 S2410-01-10GE-24P - Mac Access-Group (Port Channel)

296 | LAG/Port Channel Commands
www.dell.com | support.dell.com
Default
none
Mode
Interface Port Channel Config
Command
History
mac access-group (port channel)
This command attaches a specified MAC Access Control List (ACL) identified by name to the
selected port channel in the ingress direction.
Syntax
mac access-group name [1-4294967295]
The no mac access-group name command removes the specified MAC ACL from the port
channel.
Modes Interface Port Channel Config
Command
History
Parameters
1–199
Enter the number of the ACL, which was assigned using the access-list command.
1-4294967295
(OPTIONAL) Enter a sequence number that indicates the desired order
of this ACL relative to other ACLs already assigned to this LAG. A
lower number indicates higher precedence order. If the number is
already in use for this LAG, this ACL replaces the currently attached
ACL using that sequence number. If you do not specify a number with
this command, a number that is one greater than the highest sequence
number currently in use for this LAG is used for this ACL.
Version 2.5.1 Introduced in the new Interface Port Channel Config mode
Related
Commands
access-list Creates an IP access control list
interface range Defines an interface range and accesses the Interface Range mode
interface port-channel Defines a port channel and invokes the Interface Port Channel Config mode
ip access-group (Interface) Attaches an ACL to the selected interface (Interface Config or Interface
Range modes)
show ip access-lists Displays an IP Access Control List (ACL) and all of the rules that are defined
for the ACL. The accesslistnumber is the number used to identify the ACL
Parameters
name
Enter the name assigned by the mac access-list extended command.
1-4294967295
(OPTIONAL) This is a sequence number that will indicate the
order of application of this ACL relative to other ACLs assigned to
this port channel. A lower sequence number indicates higher
precedence order. If the number you select is already in use for this
port channel, this ACL replaces the currently attached ACL using
that sequence number. If you do not specify a number with this
command, a number that is one greater than the highest sequence
number currently in use for this port channel is used for this ACL.
Version 2.5.1 Introduced, along with its Interface Port Channel Config mode