Dell Force10 S2410-01-10GE-24P Command Reference

VLAN Commands | 151
• mode dvlan-tunnel on page 153
• show dot1q-tunnel on page 154
• show dvlan-tunnel on page 155
• show dvlan-tunnel l2pdu-forwarding on page 155
dvlan-tunnel l2pdu-forwarding enable
This command is used to enable/disable the l2pdu-forwarding mode, used for BPDU tunneling.
Syntax
[no] dvlan-tunnel l2pdu-forwarding enable
The no version of this command disables the l2pdu-forwarding mode.
Default
Enable
Mode
Global Config
Command
History
Related
Commands
dvlan-tunnel l2pdu-forwarding mac-address
This command sets/clears the l2pdu-forwarding MAC address.
Syntax
[no] dvlan-tunnel l2pdu-forwarding mac-address mac-addr
Default
01:01:E8:00:00:00
Mode
Global Config
Command
History
Version 2.5.2 Unsupported: This command was not tested in SFTOS 2.5.2, so is not supported
Version 2.5.1 Unsupported: This command was not tested in SFTOS 2.5.1, so is not supported
Version 2.3.1.9 Introduced
dvlan-tunnel
l2pdu-forwarding
mac-address
Set/clear the l2pdu-forwarding MAC address.
show dvlan-tunnel
l2pdu-forwarding
Displays the current l2pdu tunneling configuration on the switch.
show dvlan-tunnel Displays whether an interface is enabled for Double VLAN Tunneling, along with
the system-configured etherType and detailed information about Double VLAN
Tunneling for the specified interface, or a list of interfaces and their tunneling status.
Version 2.5.2 Unsupported: This command was not tested in SFTOS 2.5.2, so is not supported
Version 2.5.1 Unsupported: This command was not tested in SFTOS 2.5.1, so is not supported
Version 2.3.1.9 Introduced

Dell Force10 S2410-01-10GE-24P Specifications

General

Manageable	Yes
Jumbo Frame Support	Yes
Product Type	Switch
Uplink Ports	4 x 10 Gigabit SFP+
MAC Address Table Size	32K entries
Operating Temperature	0 °C to 40 °C
Storage Temperature	-40 °C to 70 °C
Power Supply	Internal