Dell Force10 S2410-01-10GE-24P - Protected-Port (PVLAN) Commands; Vlan Tagging; Vlan Untagging

VLAN Commands | 147
Mode
Interface Config; Interface Range, which is indicated by the (conf-if-range-interface)# prompt, such as
(conf-if-range-vlan 10-20)#.
Command
History
Related
Commands
vlan tagging
This command sets tagging to enabled for the selected interface in a specified VLAN.
Mode
Interface Config; Interface Range, which is indicated by the (conf-if-range-interface)# prompt, such as
(conf-if-range-vlan 10-20)#.
Command
History
Related
Commands
vlan untagging
This command sets tagging to disabled for the selected interface in a specified VLAN.
Mode
Interface Config
Command
History
Related
Commands
Protected-Port (PVLAN) Commands
The commands in this section are:
• show interfaces switchport on page 148
• show switchport protected on page 148
• switchport protected (Global Config) on page 149
• switchport protected (Interface Config) on page 150
Version 2.5.1 Removed from CLI
Version 2.3
Deprecated
untagged Adds a Layer 2 interface to the selected VLAN as an untagged interface.
Version 2.5.1 Removed from CLI
Version 2.3 Deprecated
tagged Sets tagging to enabled for a specified interface in the selected VLAN.
untagged Adds a Layer 2 interface to the selected VLAN as an untagged interface.
Version 2.5.1 Removed from CLI
Version 2.3 Deprecated.
untagged Adds a Layer 2 interface to the selected VLAN as an untagged interface.