Dell Force10 S2410-01-10GE-24P - Snmp Trap Link-Status All; Snmptrap Snmpversion

System Management Commands | 85
snmp trap link-status all
This command enables link status traps for all interfaces.
Syntax
[no] snmp trap link-status all
The no version of this command disables link status traps for all interfaces.
Mode
Global Config
snmptrap snmpversion
This command selects between SNMP version 1 and version 2 traps to be sent for the selected SNMP
trap name.
Syntax
snmptrap snmpversion name ipaddr {snmpv1|snmpv2}
Mode
Global Config
Note: This command is valid only when the Link Up/Down Flag is enabled. See
snmp-server enable traps linkmode.