Dell Force10 S2410-01-10GE-24P Command Reference

LAG/Port Channel Commands | 303
set garp timer leaveall
This command is available in the Interface Port Channel Config mode.
See set garp timer leaveall on page 253 in the GARP Commands chapter.
show interfaces port-channel
This command displays details about the designated LAG (port channel) or a summary of all LAGs.
Syntax
show interfaces port-channel {1–128 | brief}
Mode
Privileged Exec
Command
History
Example 1
Figure 18-109. Example of Output from show interface port-channel brief Command
Report Fields LAG — port channel number
Status — enabled/disabled
Ports — member ports
Parameters
1–128
Enter the number of the port channel, as defined in interface port-channel on
page 295
.
brief Enter brief to display the static capability of all port channels (LAGs) on the device, as
well as a summary of individual LAGs.
Version 2.5.1 Introduced, replacing show port-channel
Force10#show interface port-channel brief
Codes: L - LACP Port-channel
LAG Status Ports
--- ------ -------
1 Down 1/0/20 (Down)
1/0/21 (Down)
1/0/22 (Down)

Dell Force10 S2410-01-10GE-24P Specifications

General

Manageable	Yes
Jumbo Frame Support	Yes
Product Type	Switch
Uplink Ports	4 x 10 Gigabit SFP+
MAC Address Table Size	32K entries
Operating Temperature	0 °C to 40 °C
Storage Temperature	-40 °C to 70 °C
Power Supply	Internal