Dell Force10 S2410-01-10GE-24P - Ip Http Secure-Server Enable; Ip Http Server Enable

214 | Security Commands
www.dell.com | support.dell.com
Mode
Global Config
Command
History
ip http secure-server enable
This command is used to enable the secure socket layer for secure HTTP.
The no version of this command is used to disable the secure socket layer for secure HTTP.
Syntax
[no] ip http secure-server enable
Default
disabled
Mode
Global Config
Command
History
ip http server enable
This command enables access to the switch through the Web User Interface (Web UI) of SFTOS. When
access is enabled, the user can log in to the switch from the Web UI.
Syntax
[no] ip http server enable
Use no ip http server enable to disable access to the switch through the Web UI. When access is
disabled, the user cannot login to the switch's Web server. Disabling the Web UI takes effect
immediately. All interfaces are affected.
Default
enabled
Mode
Global Config
Command
History
Version 2.5.1
Unsupported: The
SFTOS Web UI is not supported in v. 2.5.1 or 2.5.2.
Version 2.3 Modified: Moved from Privileged Exec mode to Global Config mode.
Note: This command requires keys/certificates to be generated offline before the service
will start. See s50-secure-management.pdf at (log-in required):
https://www.force10networks.com/csportal20/KnowledgeBase/Documentation.aspx
Version 2.5.1
Unsupported: The
SFTOS Web UI is not supported in v. 2.5.1 or 2.5.2.
Version 2.3 Modified: Moved from Privileged Exec mode to Global Config mode and added
enable to the command.
Version 2.5.1
Unsupported: The
SFTOS Web UI is not supported in v. 2.5.1 or 2.5.2.
Version 2.3 Modified: Moved from Privileged Exec mode to Global Config mode and added
enable to the command.
Related
Commands
ip address (management) Configures the IP address of the management interface.