Dell Force10 S2410-01-10GE-24P - Ip Pimsm Cbsrpreference; Ip Pimsm Cbsrhashmasklength

PIM Commands | 489
ip pimsm cbsrpreference
This command is used to configure the CBSR preference for a particular PIM-SM interface. The range
of CBSR preference is –1 to 255.
Syntax
ip pimsm cbsrpreference 1-255
no ip pimsm cbsrpreference
The no version of this command is used to reset the CBSR preference for a particular PIM-SM
interface to the default value.
Default
0
Mode
Interface Config or Interface VLAN; Interface Range, which is indicated by the
(conf-if-range-interface)# prompt, such as (conf-if-range-vlan 10-20)#.
Command
History
ip pimsm cbsrhashmasklength
This command is used to configure the CBSR hash mask length to be advertised in bootstrap messages
for a particular PIM-SM interface. This hash mask length will be used in the hash algorithm for
selecting the RP for a particular group. The valid range is 0 - 32. The default value is 30.
Syntax
ip pimsm cbsrhashmasklength 0-32
no ip pimsm cbsrhashmasklength
The no version of this command is used to reset the CBSR hash mask length for a particular PIM-SM
interface to the default value.
Default
30
Mode
Interface Config or Interface VLAN; Interface Range, which is indicated by the
(conf-if-range-interface)# prompt, such as (conf-if-range-vlan 10-20)#.
Command
History
Version 2.3 Added Interface Range and Interface VLAN modes.
Related
Commands
interface range Defines an interface range and accesses the Interface Range mode
interface vlan Creates a VLAN or selects an existing one and enters the Interface VLAN mode.
Version 2.3 Added Interface Range and Interface VLAN modes.
Related
Commands
interface range Defines an interface range and accesses the Interface Range mode
interface vlan Creates a VLAN or selects an existing one and enters the Interface VLAN mode.