Dell Force10 S2410-01-10GE-24P - Show Sntp Server; Show Sntp Client

248 | Time Commands
www.dell.com | support.dell.com
show sntp client
This command displays SNTP client settings.
Syntax
show sntp client
Mode
Privileged Exec
Example
Figure 14-87. show sntp client Command Example
Field
Descriptions
Client Supported Modes—Supported SNTP Modes (broadcast and/or unicast)
SNTP Version—The highest SNTP version the client supports
Port—SNTP Client Port
Client Mode—Configured SNTP Client Mode
Poll Interval—If enabled, the poll interval value for SNTP clients in seconds as a power of two
Poll Timeout—If enabled, the poll timeout value in seconds for SNTP clients
Poll Retry—If enabled, the poll retry value for SNTP clients
show sntp server
This command is used to display SNTP server settings and configured servers.
Syntax
show sntp server
Mode
Privileged Exec
Example
Figure 14-88. show sntp server Command Example
Force10# show sntp client
Client Supported Modes: unicast broadcast
SNTP Version: 4
Port: 123
Client Mode: disabled
Force10#
Force10# show sntp server
Server IP Address:
Server Type: unknown
Server Stratum: 0
Server Reference Id:
Server Mode: Reserved
Server Maximum Entries: 3
Server Current Entries: 0
No SNTP Servers exist.
Force10#