Dell Force10 S2410-01-10GE-24P - Igmp Mrouter Interface Enable; Set Igmp (System)

278 | IGMP Snooping Commands
www.dell.com | support.dell.com
Mode
Interface Config; Interface Port Channel Config; Interface Range, which is indicated by the
(conf-if-range-interface)# prompt, such as (conf-if-range-vlan 10-20)#.
Command
History
igmp mrouter interface enable
This command configures a selected interface as a multicast router interface. When configured as a
multicast router interface, the interface is treated as a multicast router interface in all VLANs.
Syntax
[no] igmp mrouter interface enable
The no version of this command disables the status of the interface as a statically configured multicast
router interface.
Default
disable
Mode
Interface Config; Interface Port Channel Config
Command
History
Related
Commands
set igmp (interface)
Command
History
Related
Commands
set igmp (system)
Command
History
Version 2.5.1 Modified: Added Interface Port Channel Config mode.
Version 2.3
Modified: Revised from
set igmp mrouter. Added Interface Range mode.
Related
Commands
igmp enable (interface) Enables IGMP Snooping on a selected interface.
interface range Defines an interface range and accesses the Interface Range mode
interface Identifies an interface and enters the Interface Config mode.
Version 2.5.1 Modified: Added Interface Port Channel Config mode.
Version 2.3
Revised from
set igmp mrouter interface.
igmp enable (interface) Enables IGMP Snooping on a selected interface.
Version 2.3
Revised to
igmp (interface).
igmp enable (interface) Enables IGMP Snooping on a selected interface.
Version 2.3 Changed to igmp enable (global)