Dell Force10 S2410-01-10GE-24P - Page 165

Link Layer Discovery Protocol (LLDP) Commands | 165
Example
Figure 8-57. Example Output from show lldp interface Commands
show lldp local-device
Display LLDP configuration for all interfaces.
Syntax
show lldp local-device {all | unit/slot/port}.In an SVL system, the [fdbid/all] parameter is not
used and will be ignored if entered.
Default
none
Mode
Privileged Exec
Command
History
Force10 #show lldp interface 1/0/1
LLDP Interface Configuration
Interface Link Transmit Receive Notify TLVs Mgmt
--------- ------ -------- -------- -------- ------- ----
1/0/1 Down Disabled Disabled Disabled N
TLV Codes: 0- Port Description, 1- System Name
2- System Description, 3- System Capabilities
Force10 #show lldp interface all
LLDP Interface Configuration
Interface Link Transmit Receive Notify TLVs Mgmt
--------- ------ -------- -------- -------- ------- ----
1/0/1 Down Disabled Disabled Disabled N
1/0/2 Down Disabled Disabled Disabled N
1/0/3 Down Disabled Disabled Disabled N
1/0/4 Down Disabled Disabled Disabled N
1/0/5 Down Disabled Disabled Disabled N
----------!output truncated!-----------------------
Related
Commands
lldp mode (global) Enable/disable LLDP globally.
lldp mode (interface) Enable/disable LLDP on a selected interface.
clear lldp neighbors Clear LLDP neighbor information.
Parameters
interface unit/slot/port For a particular interface, enter its ID in unit/slot/port format.
all Enter the keyword all for all interfaces.
Version 2.5.1 Introduced