Dell Force10 S2410-01-10GE-24P - Page 453

RIP Commands | 453
Syntax
ip rip send version {1 | rip1c | 2 | none}
To revert to the default of sending RIP version 2 using multicast, use the no ip rip send version
command.
Default
2
Mode
Interface Config; Interface VLAN; Interface Range, which is indicated by the
(conf-if-range-interface)# prompt, such as (conf-if-range-vlan 10-20)#.
Command
History
hostroutesaccept
This command enables the RIP hostroutesaccept mode.
The no version of this command disables the RIP hostroutesaccept mode.
Syntax
[no] hostroutesaccept
Default
enabled
Mode
Router RIP Config
split-horizon
This command sets the RIP split horizon mode.
The no version of this command sets the default RIP split horizon mode.
Syntax
[no] split-horizon {none | simple | poison}
Default
simple
Mode
Router RIP Config
redistribute
This command configures RIP protocol to redistribute routes from the specified source protocol/
routers. There are five possible match options. When you submit the command redistribute ospf match
<match-type> the match-type or types specified are added to any match types presently being
redistributed. Internal routes are redistributed by default.
The no version of this command de-configures RIP protocol to redistribute routes from the specified
source protocol/routers.
Version 2.3 Added Interface Range and Interface VLAN modes.
Modified: Replaced
rip1 | rip2 keywords with 1|2.
Related
Commands
interface range Defines an interface range and accesses the Interface Range mode
interface vlan Creates a VLAN or selects an existing one and enters the Interface VLAN mode.