D-Show Profile Guide112
To select the Solo mode on-screen:
1 Go to the Options page and click the Busses tab.
2 Under Solo and Monitor Operations, select the Solo mode.
Solo States and Modes when Loading Shows
Channel Solo States
When you load a Show file, all solos are cleared. Solo states are
not saved with Show files.
Solo Mode
Show files do not open in SIP mode. If you save a Show file
while in SIP, when you reopen the Show file, it will open in
AFL Solo mode.
Solo Operation Options
Momentary or Latching Switch Operation
Channel solo switches can operate with either momentary or
latching behavior.
To engage momentary solo on a channel:
■ Hold the solo switch for more than one second. Release the
solo switch to unsolo the channel.
To latch solo on a channel:
■ Press and release the solo switch. Press the switch a second
time to unsolo the channel.
Auxes/Variable Groups Follow AFL
The “Auxes/Variable Groups Follow AFL” option is especially
useful for monitor mixing, because it provides instant access
to any mix by the soloing the mix output (in AFL mode).
When this option is selected, soloing an Aux output bus or
Variable Group output bus (by pressing its AFL switch) assigns
the Send level and pan controls for that bus to be displayed on
the Input Channel Encoder rows.
◆ Soloing a Variable Group bus automatically toggles display
of Variable Groups on the Input Encoders.
◆ With mono Aux or Variable Group busses, Send level is as-
signed to the Input Encoders.
◆ With stereo (linked) Aux or Variable Group busses, Send
level is assigned to the encoders. When Flip to Faders is
pressed, send level is flipped to the faders and send pan for the
Aux (even numbered send) is automatically mapped to the in-
put encoders. The pan button flashes while this mode is en-
abled.
To set Auxes and Variable Groups to display send controls when
soloed:
1 Go to the Options page and click the Busses tab.
2 Under Solo and Monitor Operation, select the “Auxes Fol-
low AFL” or “Auxes/Variable Groups Follow AFL” option.
3 Solo an Aux or Variable Group output bus by pressing its
AFL switch.
To cancel display of Aux and Variable Group send controls:
■ Unsolo the Aux or Variable Group output bus. The Input
Encoder rows return to the previous display.
– or –
■ Select any other parameter for the Input Channel encoders
to override the Aux follows AFL display. The encoders display
the selected parameter until another output is soloed.
Solo and Monitor Operations options
If the encoders were already flipped to the faders, flipped
status is maintained when an Aux or Variable Group
bus is soloed.
To Next Page
Loading...
Need help?
General
