D-Show Profile Guide192
Pre Settings
Snapshots can be used to recall the preamplifier settings on in-
puts for all scoped Input Channels. You can set any of the fol-
lowing Pre parameters to be recalled by the Pre data type but-
ton: Gain, Pad and Phase/polarity, +48V (Phantom Power),
HPF corner frequency and in/out state.
To set the Pre parameters recalled by the Pre Data Type button:
1 Go to the Options page and click the Snapshot tab.
2 Under Pre, select the options you want to include. Selected
items will be affected when the Pre data type is included in the
scope of a snapshot.
Classifying Auxes and Variable Groups
You can classify Aux Sends and Variable Group Sends as
monitor sends (“Mon”) or as effects sends (“FX”), which lets you
scope each type separately from the Snapshots page.
To classify Aux Sends and Variable Groups for snapshot scope:
1 Go to the Options page and click the Snapshots tab.
2 For each Aux Send or Variable Group bus or bus pair, click
the “Aux Mon” or “Aux FX” buttons to classify it as a monitor
send or effects send, respectively.
Aux Pre/Post State
Select this option to include the pickoff point pre-fader or
post-fader state of each Aux Send or Variable Group in snap-
shots.
Setting Pre parameters
This option is only a means of organizing Aux Sends for
snapshot control, and does not directly affect Aux bus or
Variable Group bus operation.
Classifying Aux Sends and Variable Groups
To Next Page
Loading...
Need help?
General
