Chapter 9: Groups 83
Working with Stereo Group Busses
When configured as stereo busses, Groups can operate in the
following modes:
Simple Mode
In Simple Mode, all 8 Group busses function only as true ste-
reo busses.
Expert Mode
In Expert Mode, any of the 8 stereo Group busses can be set to
act as true stereo or as dual mono busses, on a per channel ba-
sis.
To set the link status of individual stereo Group busses for a
channel (Expert Mode only):
1 Make sure Stereo Group Panning is set to Expert Mode.
2 Select an Input Channel or FX Return whose signal you
want to route to a Group bus. To select multiple channels, use
the Multi-Select switch next to the input faders.
3 In the ACS Bus Assigns section, press the Stereo Pan switch.
The switch flashes yellow to indicate bus link mode.
4 Press any of the Group switches (1–8) to set the correspond-
ing bus to stereo or dual mono. The Group switches flash yel-
low to indicate stereo, or flash green to indicate dual mono.
5 Press the flashing Stereo Pan switch to confirm the bus link
status for the selected channels.
To use dual mono Group busses (Expert Mode only):
1 Make sure the Group busses are configured as stereo busses.
See “Configuring Aux, Group, and Variable Group Busses” on
page 70.
2 Make sure the link status of the Group busses you want to
use is set to dual mono.
When routing channels to a dual mono Group bus, the Stereo
Pan switch will be off and the Group switch will light green to
indicate dual mono operation.
To Next Page
Loading...
