Dynamic CCTV EZ960 - Daylight Saving Time; DST Start; End

OSD Setup Manual
12
NOTE: <Time Zone> must be set to users’ local time zone or the <Network
Time Protocol Setup> will not be accessible.
 Date/Time Display
Select <ON> or <OFF> to setup whether to display date/time information on the
screen. Press ENTER and use the UP / DOWN keys to change the setting.
 Date Display Mode
This menu allows users to set the display type of the date. Three options are
provided: <Y/M/D>, <M/D/Y> or <D/M/Y>. “Y” represents “Year”, “M” represents
“Month” and “D” represents “Day”. Use UP / DOWN keys to change the setting.
 Time Display Mode
Users can set the time format to <12 HR> or <24 HR>. Use the UP / DOWN keys
to change the format.
 Daylight Saving Time Setup
This function is for people who live in certain regions to observe Daylight Saving
Time. The menu displays as follows:
Daylight Saving Time Setup
Daylight Saving Time
DST Start
DST End
DST Bias
Off
Apr 1st Sun 01:00
Oct Last Sun 01:00
60 Min
- Daylight Saving Time
Select <On> to enable, or <Off> to disable the function. If the function is
disabled, the DST Start / End time and DST Bias will be grayed out and
cannot be accessed. If this function is enabled, the date/time information
will be shown on the screen with a DST icon when playing back recorded
video or searching video in the event list. “S” indicates summer time and
“W” indicates winter time.
- DST Start / End
These items are used to set duration of daylight saving time. Use LEFT /
RIGHT to move the cursor to the previous or next field, UP / DOWN to
change the settings.