Dynamic CCTV EZ960 - Input Setup; Camera Selection; Input Source; Manual Filter Setup

OSD Setup Manual
62
Inside The Range:
The value of transaction within a certain range will be marked as an exception. The
specific value needs to be set through the following sub-menus <Value> and
<Value (Upper Limit)>.
Outside the Range:
The value of transaction outside a certain range will be marked as an exception.
The specific value needs to be set through the following sub-menus <Value> and
<Value (Upper Limit)>.
NOTE: Transactions will only be marked as exceptions in the text database
after “Exception String” and “By Numerals” are set AND “Trigger” is <ON>.
The data that has been stored before will not be marked as exceptions.
< Input Setup >
This item is used to choose the connection method between the POS Device and the DVR.
Also some relative settings of the connection method can be configured.
Input Setup
Input Source
Camera Selection
Text Filter
Manual Filter Setup
Input Process
Text Baud Rate
Text Bits
Text Stop
Text Parity
Direct Connected
1
ASCII
Canonical
9600
8
1
None
 Input source
Select whether the input source is directly connected or connected with the Data
Converter. If the input source is directly connected, users may need to go to the
next item, Camera Selection, to select a corresponding camera.
 Camera Selection
Select a camera to display the POS overlay.