OSD Setup Manual
51
Database Setup
The menu displays information of internal and external HDDs. In the main menu, select
<Database Setup> and press ENTER. The following menu is displayed.
Database Setup
Total Size
Free Size
Avail. Rec Time
Internal Disks
Data Protection
Repair On Power Loss
xxxGB
xxxGB (Circular)
Circular
On
NOTE: If the detection of HDDs fails, the message “HDD fail” will be displayed.
< Total / Free Size >
Total Size shows the total storage capacity of HDDs that have been added to the database.
Free Size indicates free storage space available for recording in the database. “Circular”
will be shown if the DVR is set to record in circular mode. Both of them are read-only.
< Avail. Rec Time >
This item indicates the available time duration for recording. If the DVR is set to record in
circular mode, this item will show “Circular”. This information is read-only as well.
NOTE: If VBR mode is selected in <Record Mode Setup>, the available time will not
be able to be calculated. Thus there will be no value displayed for this item.
< Internal Disks >
Select <Internal Disks> to see information of the built-in HDDs. The menu is displayed as
below.
Internal Disks
Device Name
#: xxxxxxx-xxxxxx
Active
Action
None
The information of the built-in HDDs will be listed by model name and status. If no storage
device is connected to the DVR, the message “No Available Items!” will be displayed.
NOTE: If the file system of the internal HDDs is not compatible for the DVR, the
system will format the internal HDDs automatically without notice.
To Next Page
Loading...