Dynamic CCTV EZ960 - Alert Configuration Set; Alert IP; Alert Notification; Alert Port

OSD Setup Manual
44
 Alert Configuration Set
<Alert Configuration Set> provides 3 combinations of Alert Notification, IP, and
Port.
 Alert Notification
4 options are included in this item; <OFF>, <Event>, <Alive>, and <Both>.
<OFF>: The Alert Notification is turned off.
<Event>: When the alarm is triggered, the DVR will send an alert message to the
CMS.
<Alive>: The DVR will send an alive message to the CMS every N second just to
show users that the connection between the DVR and CMS is in effect.
The time interval N can be adjusted in <Alive Interval>.
<Both>: This enables the DVR to send both Event and Alive alert messages to
the CMS.
 Alert IP
The Alert IP must match the IP address of the computer.
 Alert Port
The ports for DVR and the CMS Alert MUST be the same.
 Alive Interval
Users can define the time interval (1 to 255 seconds) between each alive message.
This item will not be accessible if the alert notification menu is set to <OFF> or
<Event>.
< Event Full Screen >
This function allows the DVR to display the alarm channel in full screen size when an alarm
is triggered.
Select <None> to disable this function, <Main> to display the alarm channel on Main
Monitor when an alarm is triggered, <Call> to display the alarm channel on Call Monitor, or
select <Both> to display the alarm channel on both Main Monitor and Call Monitor.
< Event Duration >
This item determines the duration of the buzzer and Alarm Out relay function after an alarm
is triggered. The available event duration range is from 5 second to 999 seconds.