Dynamic CCTV EZ960 - Camera Setup; Analog Camera; Analog Camera Select; Camera Name

OSD Setup Manual
30
Camera Setup
The items in the Camera Setup menu enable users to set camera parameters, including
camera title, dome protocol and ID for each connected camera.
< Analog Camera >
If the connected camera is an analog camera, please continue with this section. Items in
this menu are described in the following subsections.
Camera Setup
Analog Camera Select
Dome Protocol
Dome ID
Camera Name
Hidden
Adjust Video
Copy Settings
CH01
None
0
CH1
No
 Analog Camera Select
This item is used to select a camera for setting the parameters. The related
settings will follow the selected camera, such as dome protocol and camera title.
Move the cursor to <Analog Camera Select> and press ENTER, then select a
channel using UP / DOWN keys.
 Dome Protocol
If the connected camera is a dome camera, select the communication protocol
associated with the dome camera using ENTER and Direction keys. The available
protocol includes <DSCP>, <AD422>, <Pelco D>, <Pelco P>, <Fastrax 2>, <JVC>,
<Panasonic_C> and <Panasonic_N>. The default is set to <None>.
 Dome ID
This item is used to assign an ID number to the selected dome camera. Note that
ID number must match the ID address set by the dome camera.
 Camera Name
This item allows the users to change the name of each connected camera. By
default, the names of cameras are numbered from 1 through 16 respectively. The
names will be displayed on screen after the changes of the names are set.