OSD Setup Manual
54
Configuration
The Configuration menu can be used to restore the default factory settings, import/export
configuration, and view/export system log. Select <Configuration> from the main menu and
press ENTER. The following menu is displayed. Items in this menu are described in the
following subsections.
Configuration
Load Factory Default
Import Config
Export Config
System Log
Operation Log
No
Off
< Load Factory Default >
This item is used to load the factory default setting. Select <Yes> to restore the factory
default setting from the read-only memory, or select <No> to cancel.
< Import Configuration >
This item allows users to load a DVR configuration that was saved in an external drive. To
import a configuration that was previously exported, make sure the device with the saved
configuration is connected to the DVR. Select <Import Config> from the Configuration
menu and press ENTER. The following menu is displayed.
Import Config
Config Name
xxxx-xxxx
xxx-xx
Select
No
No
Press UP/ DOWN to select one of the available configuration files, and choose <Yes> to
start importing the configuration.
NOTE: If the record mode of the imported configuration is different from the DVR’s
current configuration, a warning message will be shown and the system will reboot.
NOTE: DO NOT remove the external device before the DVR completely reboots,
otherwise it will be formatted.
To Next Page
Loading...