Dynamic CCTV EZ960 - Load Default Setting; Network Setup; LAN Select

OSD Setup Manual
16
NOTE: The “Menu Access” cannot be set to <Disable>.
When the account does not have authority to access certain functions, an error
message will be displayed on the screen.
 Load Default Setting
This item is for restoring the default settings. Select <Yes> to load default setting or
select <No> to exit.
< Network Setup >
The Network Setup menu allows users with proper privilege to configure the network by
specifying the network related settings, such as IP address and Netmask, etc. Check with
the network administrator and/or network service provider for more specific information.
The menu is as the following. Items in this menu are described in the following sections.
Network Setup
LAN Select
LAN Setup
Web Port
DDNS Setup
UPnP Setup
LAN
80
 LAN Select
This item allows users to select the network type among <LAN>, <PPPoE>, and
<None>. If the internet connection is a local area network communication, please
select <LAN>. If the internet connection is a broadband medium, such as DSL Line
or cable modem, please select <PPPoE>. PPPoE stands for Point-to-Point
Protocol over Ethernet. It is a specification for connecting the users on an Ethernet
to the Internet through a common broadband medium.
If <None> is selected, then there is no need to set further LAN or PPPoE settings.
Therefore, the second item <LAN Setup>will be inaccessible.