OSD Setup Manual
26
- Min Remaining Battery Level
For this item, users can decide the NVR should begin to shutdown when
the remaining battery level reaches the specific percentage. The ranges
are from 5% to 95%.
- Min Remaining Run Time
For this item, users can decide the NVR should begin to shutdown when
the remaining run time reaches the specific value. The ranges are from 5
minutes to 30 minutes.
- Delay To Activate
This item allows users to set delay time before the NVR begin to
shutdown. The ranges are from 10 seconds to 20 seconds.
UPS Info
After UPS protocol is selected, this item will become available. Users can check
out UPS related information as shown below.
UPS Info
UPS Model
UPS Protocol
UPS Status
Remaining Battery Level
Remaining Run Time
Query Time
*****
*****
Lost Communication
77 %
93 mins
16 secs ago
- UPS Model
This item shows the model name of the UPS device.
- UPS Protocol
This item shows the protocol of the UPS device.
- UPS Status
This item will show the connection status between the NVR and the UPS
device. Refer to below for the description of each displayed value.
Unknown
This will be displayed when there is no UPS device connected.
To Next Page
Loading...