Dynamic CCTV EZ960 - Dhcp; LAN Setup

OSD Setup Manual
17
 LAN Setup
The network related settings in the LAN Setup menu should be associated with the
network service type. Select <LAN Setup> in Network Setup menu and press
ENTER to set the parameters. The menu displays as follows.
LAN Setup
DHCP
IP
Netmask
Gateway
DNS
PPPoE Account
PPPoE Password
PPPoE Max Idle
Connect At Booting
Network Restart
Off
192.168.1.150
255.255.255.0
192.168.1.1
0.0.0.0
35 Min
Yes
No
- DHCP
This item allows users to obtain a dynamic IP address from DHCP
(Dynamic Host Configuration Protocol) server when the DVR boots up.
When using DHCP, the settings are dynamic and will change every time
the DVR power on or off, depending on the network's setup.
If the item is enabled (On), a dynamic IP will be assigned to
Versatile/Lite H.264 DVR. In this case, users do not need to set a static
IP and the Ethernet settings, including IP address, Netmask, Gateway,
and DNS settings will be read-only.
If the DVR is using a permanent address, disable DHCP (Off) to manually
set IP Address, Netmask, Gateway, and DNS. See the network system
administrators or IT personnel for appropriate values.
- IP
This item is used to configure the IP (Internet Protocol) address of the
DVR. The IP address is the identifier for the DVR on a TCP/IP LAN.
Please note that to set a static IP address, DHCP must be set to <Off>.