F15 Series Fetal & Maternal Monitor User Manual Fetal Monitoring
- 94 -
1 Select the main menu key on the main interface.
2 Select Fetus > MFM Volume.
3 Select Low or High (default).
4 Select OK.
7.9 *Start Monitoring
After the START key is pressed, the monitor automatically zeroes the pressure, clears the FM count
and starts monitoring.
If the Auto start printing is disabled, press the PRINT key to start printing.
7.10 *Inputting Maternal Information (Mat. Info)
7.10.1 Auto ID
After you press the START key, the system creates an auto-ID for the present patient. (if Mat. Info
inputting is switched off.) The auto-ID consists of the date and time when the monitoring starts.
7.10.2 Changing Maternal Information
You can change the patient’s information after the monitoring starts:
1 Select Mat. Info key on the main interface.
Figure 7-13 Mat. Info Inputting Menu
2 Select ID.
Figure 7-14 Soft Keyboard
3 Select the required character for patient’s ID on the soft keyboard.
4 Select Enter.
5 Select Name.
6 Select the required letter for patient’s name on the soft keyboard.
7 Select Enter.
8 Select OK.
The monitoring does not stop when you change maternal information. After you select OK to exit, the
Traditional 510(k) of Fetal & Maternal Monitor
014_14.1_F15_Series_User_Manual
To Next Page
Loading...
Need help?
General
