F15 Series Fetal & Maternal Monitor User Manual Installation
- 8 -
Chapter2 Installation
WARNING
The system installation should be operated by serviceman authorized by the manufacturer.
2.1 Opening the Package and Checking
Visually examine the package prior to unpacking. If any signs of mishandling or damage are detected,
contact the carrier to claim for damage.
Open the package; take out the monitor and accessories carefully. Keep the package for possible
future transportation or storage. Check the components according to the packing list.
Check for any mechanical damage.
Check all the cables and accessories.
If there is any problem, contact us or your local distributor immediately.
2.2 Installing Battery
If your monitor has been configured with the rechargeable lithium-ion battery, follow these steps to
install the battery:
WARNING
1 Switch off the monitor and unplug it before installing or removing the battery.
2 Make sure the battery has been installed before using the monitor.
(1) Battery Installation
a) Carefully place the monitor upside down on a flat surface covered with cloth or other type of
protecting pad.
b) Remove the screws of the battery compartment using a cross-head screw driver. Remove the
battery compartment cover.
c) Take the battery out from package, with the label side facing up.
d) Put the battery and the cables into the battery compartment and insert the cable connector into
the socket.
Traditional 510(k) of Fetal & Maternal Monitor
014_14.1_F15_Series_User_Manual
To Next Page
Loading...
Need help?
General
