F15 Series Fetal & Maternal Monitor User Manual Maintenance and Cleaning
- 120 -
Chapter10 After Monitoring
10.1 Completing Monitoring
After monitoring,
1) Remove transducers or electrodes from the patient; wipe the remaining gel off the patient
and the transducer with a clean soft cloth or tissue.
2) Press the PRINT key to stop printing, and press the paper advancing key to advance
the paper.
3) Wait the paper to stop and then tear it off along the perforation.
NOTE:
After the fetus is delivered in the labor, the monitor may pick up signals of the umbilical cord
or maternal abdominal aorta and display a trace/numeric. To avoid misinterpretation, it is
recommended to remove the transducers from the patient and switch off the monitor
immediately after the fetus is delivered.
10.2 Switching Off
1) Press and hold the POWER switch for at least 3 seconds to switch off the monitor.
2) Unplug the power cord.
CAUTION
Do not press the POWER switch continuously. Allow at least 10 seconds between switching
the monitor on and off.
Traditional 510(k) of Fetal & Maternal Monitor
014_14.1_F15_Series_User_Manual
To Next Page
Loading...
Need help?
General
