F15 Series Fetal & Maternal Monitor User Manual Installation
- 9 -
e) Shut the battery compartment cover and fix the screws.
(2) Battery Removal
Fold the LCD display completely flat before turning the monitor upside down. Remove the battery in
reverse order.
NOTE:
1 If a rechargeable battery is outfitted, charge it fully each time after using the device to
ensure the electric power is enough.
2 After the device is transported or stored for a long time, charge the battery fully before use.
Connecting to power supply will charge the battery no matter if the monitor is powered on.
3 Do not pull the battery cables, or the battery may become damaged.
2.2.1 Patient Transfer Within the Hospital
The battery in the monitor provides the opportunity of transferring a patient within the hospital without
interruption in monitoring.
1 Unplug the power cable from the monitor, now the monitor is operating on battery power.
2 Transfer the patient with the monitor (on a trolley) to the new location.
3 Reconnect the power cable to the monitor.
2.3 Installing Monitor
The monitor can be placed on a flat surface, or be installed on a wall or a trolley. The service engineer
should install the monitor properly.
CAUTION
If you choose to install the monitor on the wall, it is the user’s responsibility to ensure their
integrity and solidity evaluated by a registered, professional structural or mechanical engineer
and compliance with all local regulations. The manufacturer will not be responsible for the
failure and loss of any improper installation.
2.4 Loading Recorder paper
WARNING
1 Only use the recorder paper provided by the manufacturer, otherwise the recorder may be
damaged. This kind of damage is not covered by warranty.
Traditional 510(k) of Fetal & Maternal Monitor
014_14.1_F15_Series_User_Manual
To Next Page
Loading...
Need help?
General
