EDAN F15 Series User Manual

F15 Series Fetal & Maternal Monitor User Manual Installation
- 12 -
2.6 Installing Transducer Holder Bracket
You can choose to install the transducer holder bracket on the wall or on the trolley.
Please refer to MT-811 Trolley (For medical use) Assembling Instruction for method to install it on the
trolley.
The method to install it on the wall is as below.
Method to install wireless transducer holder bracket (Plan A):
1. Mark the location of mounting holes of wireless transducer holder bracket on the wall and then
use a Ф6 drill to punch the wall.
2. Knock three 6mm plastic expand tubes into the punched holes.
3. Fix the wireless transducer holder bracket on the wall with three ST2.9*12 tapping screws.
4. Fix the wireless transducer holder bracket on the supporting bracket with two M3*8 pan head
screws, and then fill two silicon plugs in the mounting holes of wireless transducer holder bracket.
Method to install wireless transducer holder bracket (Plan B):
1. Mark the location of mounting holes of wireless transducer holder bracket on the wall and then
use a Ф6 drill to punch the wall.
2. Knock three6mm plastic expand tubes into the punched holes.
3. Fix the wireless transducer holder bracket on the wall with three ST2.9*12 tapping screws.
Method to install wired transducer holder bracket:
6mm plastic expand tube
Supporting bracket for
Wireless transducer holder bracket
M3*8 pan head screw
Wireless transducer
holder bracket
ST2.9*12 tapping
screw
Wall
Wall
6mm plastic expand tube
Wireless transducer holder
bracket
ST2.9*12 tapping
screw
Traditional 510(k) of Fetal & Maternal Monitor
014_14.1_F15_Series_User_Manual
28／202

EDAN F15 Series Specifications

General

Brand	EDAN
Model	F15 Series
Category	Monitor
Language	English