EDAN F15 Series User Manual

F15 Series Fetal & Maternal Monitor User Manual Printing
- 69 -
5.2 Printing Configuration
NOTE:
All the parameters should be well configured before printing starts. You cannot change the
configuration in the process of printing.
5.2.1 Switching Auto Start Printing On or Off
You can switch auto start printing on or off:
1 Select the main menu key
on the main interface.
2 Select Start Monitoring > PRINT.
3 Select ON or OFF (default).
4 Select OK.
5.2.2 *Choosing the Paper Speed
You can choose a paper speed of 1 cm/min, 2cm/min or 3cm/min:
1 Select the main menu key
on the main interface.
2 Select Recorder > Print Speed.
3 Select 1 cm/min, 2 cm/min or 3 cm/min (default).
4 Select OK.
NOTE:
Different paper speed setting causes different FHR trace appearance on the record paper. To
avoid misinterpretation, we recommend you to set all monitors in your institution to the same
paper speed.
5.2.3 *Changing the Print Timer
1 Select the main menu key on the main interface.
2 Select Recorder > Timer.
3 Set timer to 10 ~ 90 (minutes, the step is 5) or Infinite (default). For a fixed time, the recorder
stops when the time is up. For Infinite, there is no time limit. Whatever the setting is, the
recorder stops when this patient’s traces come to the end or if the PRINT key is pressed in
midway.
4 Select OK.
5.2.4 Switching Print Self-Check On or Off
You can choose to switch print self-check on or off:
1 Select the main menu key on the main interface.
2 Select Recorder > Print Self-Check.
3 Select ON (default) or OFF.
4 Select OK.
5.2.5 Changing Printing End Volume
The monitor gives a tone when printing ends and this tone volume is adjustable.
Traditional 510(k) of Fetal & Maternal Monitor
014_14.1_F15_Series_User_Manual
85／202

EDAN F15 Series Specifications

General

Brand	EDAN
Model	F15 Series
Category	Monitor
Language	English