F15 Series Fetal & Maternal Monitor User Manual Installation
- 10 -
2 Configured with different hardware, the monitor is compatible with both GE and Philips
recorder paper. However, only one type of paper is configured with the monitor in the
shipment. If you want to use the other type of paper, contact the manufacturer for service
first, otherwise trace excursion or paper jam may occur.
3 Please check whether the recorder paper is correctly loaded.
4 Do not pull on the paper to advance it, as this can cause misalignment of the paper. Always
tear off the paper along the perforation.
If the monitor is used for the first time or when the paper runs out, you should load paper.
1) Pull the handle of the paper drawer and slide the drawer out carefully.
2) Take out the Z-fold thermosensitive paper and remove the wrapper.
3) Place the pack in the drawer, with the pane facing up and the FHR trace area on the left.
4) Unfold two sheets from the top of the pack and pull the end of the paper out of the drawer (make
sure the pack in the drawer remains flat).
5) Slide the drawer in until it “clicks” closed.
Traditional 510(k) of Fetal & Maternal Monitor
014_14.1_F15_Series_User_Manual
To Next Page
Loading...
Need help?
General
