F15 Series Fetal & Maternal Monitor User Manual Basic Operation
- 32 -
Function: Adjust the brightness of the screen
Press this key and the up/down key will be displayed. Press the up/down key to increase or decrease
gradually the brightness. 9 is the brightest, 0 is the least bright.
(10)PAUSE
Function: Pause/Continue monitoring
Press the PAUSE key on monitoring status, the curves of MECG, and SpO2 stop tracing; Press the
PAUSE key again, the curves restart tracing.
(11)PAT. TRANS. (F15 Air only)
Function: Admitting and discharging
Firstly, Press this key on the original monitor and select discharging to discharge all the transducers
bound to the monitor. Secondly, press this key and select admitting, input the device no. of the original
monitor, and wait until all the transducers bound to the original monitor are admitted automatically.
Patient transfer can be realized without removing the bound transducers from the body.
Note: If patient transfer is failed, take the transducer off the patient and put it back the dock, then
match it and reuse it.
(12)PAPER ADV.
Function: Advances the paper automatically
When printing stops, press this to advance the paper, making sure the paper has a perforation outside
the drawer and is easy to be torn off. Press this key and the paper will advance 8 cm automatically
(PHILIPS paper) or 7 cm (GE paper).
(13)SWITCH (Monitor configured with maternal parameters only)
Function: Switch display mode
Press this key to switch display mode among maternal-fetal mode, fetal mode and maternal mode in
order.
(14)MAT.INFO
Function: Input and revise maternal information
Press this key to input and revise maternal information.
(15)MAIN MENU
Function: Setup menu
Press this key to enter the setup menu of the monitor.
(16)PROBE OFF
When a transducer unplugged alarm, US/DECG/ECG signal weak alarm or DECG/ECG/IUP leads off
alarm or CTG alarm is active, select this key to confirm the alarm and it will be turned off audibly and
visually, but it still exists in the alarm review.
NOTE:
If the key sound is enabled, the monitor gives a normal key sound when the operation is valid,
and gives a sharp “Di” sound when the operation is invalid.
CAUTION
This monitor is a normal medical device. Please avoid violent operations such as continuously
pressing the keys.
Traditional 510(k) of Fetal & Maternal Monitor
014_14.1_F15_Series_User_Manual
To Next Page
Loading...
Need help?
General
