F15 Series Fetal & Maternal Monitor User Manual Basic Operation
- 47 -
childbirth.
2 CTG analysis is just an analysis intended to assist the physicians in interpreting the
waveforms. Conclusions should be drawn on the basis of the physicians’ diagnosis.
3 This analysis describes the fetal heart rate, the tocography and the fetal movements. It’s the
responsibility of qualified medical staff to do the diagnostic interpretation of the waveform.
To enable CTG Analysis,
1 Select the main menu key on the main interface.
2 Select General > CTG Analysis.
3 Select an analysis method: KREBS Analysis, Fischer Analysis, Improved Fischer Analysis, NST
Report, NST Analysis, NST Three-level Classification Report or OFF.
4 Select OK.
A CTG analysis key appears on the main interface, indicating that CTG
analysis is enabled.
NOTE:
1 CTG analyze starts after the real-time trace has been printed for 10 minutes.
2 The CTG analysis result is for reference only.
After the real-time trace is printed for 10 minutes, select the CTG analysis key
on the main interface. The analysis result window opens.
Figure 3-39 CTG Analysis Results
Refer to figure 3-41, the CTG analysis results on the screen include:
1) CTG Analysis Timer:
The CTG analysis timer starts when the recorder starts printing; it stops when the timer reaches
60 minutes (the timer turns into >60) and resets when the recorder stops printing.
1) CTG Analysis
Timer
2) Analysis Results
Traditional 510(k) of Fetal & Maternal Monitor
014_14.1_F15_Series_User_Manual