CONTENTS (CONTINUED)
Section Title Page
7.1.6 Overheating inside the STP pump (MOTOR Overheat) 125
7.1.7 Overheating inside the control unit (CNT Overheat) 125
7.1.8 Overspeed 125
7.1.9 Abnormality/Error in the TMS unit (for use with the TMS unit) 125
7.1.10 Safety feature of the rotor blade temperature
warning sensor (Option) 126
7.2 "WARNING" function 127
7.2.1 "WARNING" function 127
7.3 Contents of WARNING function 128
7.3.1 First Damage limit 128
7.3.2 Second Damage Limit 128
7.3.3 Pump Run Time Over 128
7.3.4 Pump Overload 129
7.3.5 Imbalance 129
7.3.6 Other Warning 130
7.4 WARNING function setting 131
7.5 Troubleshooting immediately after failure occurs 132
7.5.1 After power failure 132
7.5.2 After other abnormality/error 132
7.6 Troubleshooting 133
7.6.1 Indication of "STATUS" LED (red flash) 133
7.6.2 Indication of "STATUS" LED (green and red alternately) 141
7.6.3 No Indication of the "STATUS" LED (red) 141
8 MAINTENANCE AND INSPECTION 143
8.1 Maintenance and inspection 143
8.2 Cleaning 144
8.3 Inspecting the deposit 144
8.4 Maintenance 146
8.4.1 Recommended overhaul intervals 146
8.4.2 Standard replacement parts 146
8.4.3 Recommended maintenance intervals for main parts 147
8.5 Transporting for repair or overhaul 148
9 STORAGE AND DISPOSAL 149
9.1 Storage of the STP pump 149
9.2 Disposal 149
10 SERVICE, SPARES AND ACCESSORIES 151
10.1 Introduction 151
10.2 Service 151
10.3 Spares 151
10.4 Accessories 152
To Next Page
Loading...
Need help?
General
