ELTEX ESR-3100 - Page 255

ESR series service routers.ESR-Series. User manual
255
•
•
Step Description Command Keys
esr(config-ipv6-ospf-area)#
summary-address <IPV6-ADDR/
LEN> { advertise | not-advertise }
<IPV6-ADDR/LEN> – IPv6
address and mask of a subnet,
defined as X:X:X:X::X/EE where
each X part takes values in
hexadecimal format [0..FFFF]
and EE takes values of [1..128];
advertise – when
specifying the command
instead of the subnets
included in a subnet
specified, a total subnet
will be advertised;
not-advertise – the
subnets included in a
subnet specified will not
be advertised.
19 Enable OSFP area. esr(config-ospf-area)# enable
esr(config-ipv6-ospf-area)# enable
20 Establish a virtual connection between
the main and remote areas having
several areas between them(optional).
esr(config-ospf-area)# virtual-link
<ID>
<ID> – identifier of the router
with which the virtual
connection is established,
defined as AAA.BBB.CCC.DDD
where each part takes values
of [0..255].
esr(config-ipv6-ospf-area)#
virtual-link <ID>
21 Set the time interval in seconds after
which the router re-sends a packet that
has not received a delivery confirmation
(for example, a DatabaseDescription
packet or LinkStateRequest
packets)(optional).
esr(config-ospf- vlink)#
restransmit-interval <TIME>
<TIME> – time in seconds,
takes values of [1..65535].
Default value: 5 seconds.
esr(config-ipv6-ospf- vlink)#
restransmit-interval <TIME>
22 Set the time interval in seconds after
which the router sends the next hello
packet(optional).
esr(config-ospf- vlink)# hello-
interval <TIME>
<TIME> – time in seconds,
takes values of [1..65535].
Default value: 10 seconds.
esr(config-ipv6-ospf- vlink)# hello-
interval <TIME>
23 Set the time interval in seconds after
which the neighbor is considered to be
idle. This interval should be a multiple
of the ‘hello interval’ value.
esr(config-ospf- vlink)# dead-
interval <TIME>
<TIME> – time in seconds,
takes values of [1..65535].
Default value: 40 seconds.
esr(config-ipv6-ospf- vlink)# dead-
interval <TIME>