ELTEX ESR-3100 - AAA Configuration Algorithm Via RADIUS

ESR series service routers.ESR-Series. User manual
443
Step Description Command Keys
18 Switch to the corresponding
terminal configuration mode
esr(config)# line console
or
esr(config)# line telnet
or
esr(config)# line ssh
19 Activate user login authentication
list
esr(config-line-ssh)# login
authentication <NAME>
<NAME> – list name, set by the
string of up to 31 characters.
20 Activate authentication list of
user privileges elevation
esr(config-line-ssh)# enable
authentication <NAME>
<NAME> – list name, set by the
string of up to 31 characters.
21 Set the interval after which the
idle session will be terminated
esr(config-line-ssh)# exec-
timeout <SEC>
<SEC> – time interval in minutes,
takes values of [1..65535].
13.1.2 AAA configuration algorithm via RADIUS
Step Description Command Keys
1 Set the DSCP code global value
for the use in IP headers of
RADIUS server egress packets
(optional).
esr(config)# radius-server dscp
<DSCP>
<DSCP> – DSCP code value, takes
values in the range of [0..63].
Default value: 63.
2 Set the global number of re-
requests to the last active
RADIUS server (optional).
esr(config)# radius-server
retransmit <COUNT>
<COUNT> – amount of iterative
requests to RADIUS server, takes
values of [1..10].
Default value: 1.
3 Set the global value of the
interval after which the router
assumes that the RADIUS server
is not available (optional).
esr(config)# radius-server
timeout <SEC>
<SEC> – time interval in seconds,
takes values of [1..30].
Default value: 3 seconds.