ELTEX ESR-3100 - 18.3 Example of configuration without SoftWLC

ESR series service routers.ESR-Series. User manual
626
Activate DHCP-Relay:
esr(config)# ip dhcp-relay
Configure SNAT for gigabitethernet 1/0/1 port:
esr(config)# nat source
esr(config-snat)# ruleset inet
esr(config-snat-ruleset)# to interface gigabitethernet 1/0/1
esr(config-snat-ruleset)# rule 10
esr(config-snat-rule)# match source-address any
esr(config-snat-rule)# action source-nat interface
esr(config-snat-rule)# enable
esr(config-snat-rule)# end
18.3 Example of configuration without SoftWLC
Objective:
Configure BRAS without SoftWLC support.
Given:
Subnet with clients 10.10.0.0/16, subnet for working with FreeRADIUS server 192.168.1.1/24
Solution:
Step 1:
RADIUS server configuration.
For FreeRADIUS server, specify the subnet that can send the queries and add a user list. To do this, add the
following to the users file in the directory with FreeRADIUS server configuration files:
User profile:
<MACADDR> Cleartext-Password := <MACADDR>
User name:
User-Name = <USER_NAME>,
Maximum session lifetime:
Session-Timeout = <SECONDS>,
Maximum session lifetime when the system is idle:
Idle-Timeout = <SECONDS>,
Session statistics update time:
Acct-Interim-Interval = <SECONDS>,