ESR series service routers.ESR-Series. User manual
Solution:
Create PPTP tunnel:
esr(config)# tunnel pptp 1
Specify the account (Ivan user) to connect to the server:
esr(config-pptp)# username ivan password ascii-text simplepass
Specify the remote gateway:
esr(config-pptp)# remote address 20.20.0.1
Specify a security zone:
esr(config-pptp)# security-zone VPN
Enable PPTP tunnel:
To view the tunnel status, use the following command:
esr# show tunnels status pptp
To view sent and received packet counters, use the following command:
esr# show tunnels counters pptp
To view the tunnel configuration, use the following command:
esr# show tunnels configuration pptp
15.6 Configuring remote access client via L2TP
L2TP ( Layer 2 Tunneling Protocol) is a sophisticated tunneling protocol used to support virtual private
networks. L2TP encapsulates PPP frames into IP packets for transmission via global IP network, e.g. the
Internet. L2TP may be used for tunnel establishment between two local area networks. L2TP uses an
additional UDP connection for tunnel handling. L2TP protocol does not provide data encryption, therefore it is
usually combined with an IPsec protocol group that provides security on a packet level.
To Next Page
Loading...
Need help?
General
