ELTEX ESR-3100 - Configuration Example

ESR series service routers.ESR-Series. User manual
601
•
•
Step Description Command Keys
21 Allow different types of SNMP
notifications to be sent.
esr(config)# snmp-server enable
traps <TYPE>
<TYPE> – type of filtered
messages. May take the following
values:
config, entry, entry-sensor,
environment, envmon, files-
operations, flash, flash-operations,
interfaces, links, ports, screens,
snmp, syslog.
Additional parameters depend on
the filter type. See ESR-Series CLI
command reference guide.
22 Create the snmp view profile
permitting or denying the access
to one or another OID for
community (SNMPv2) and user
(SNMPv3).
esr(config)# snmp-server enable
traps <TYPE>
<VIEW-NAME> – SNMP view
profile name, set by the string of
up to 31 characters.
17.3.2 Configuration example
Objective:
Configure SNMPv3 server with authentication and data encryption for 'admin' user. ESR router IP address:
192.168.52.8, Syslog server IP address: 192.168.52.41.

Solution:
First, do the following:
Specify zone for gi1/0/1 interface;
Configure IP address for gi1/0/1 interface.
Main configuration step:
Enable SNMP server:
esr(config)# snmp-server
Create SNMPv3 user:
esr(config)# snmp-server user admin